About this 3D model

This whimsical piggy bank shaped like an elephant can be printed without supports. However, it is a very large model so that enough money can fit into its belly and the coins can be easily removed again. Children can let the coins roll down the trunk into the elephant's belly, making depositing and saving money even more fun! The coins are removed through a large opening at the rear feet. This can be simply opened with another coin. The interior is shaped so that the coins automatically slide to the exit and do not get stuck in the feet etc. Dimensions: approximately 28 x 27 x 8 cm [L x H x W] Scaling is not possible for more than -10%, otherwise the coins will no longer fit into the slot! Therefore I've created a smaller version “Klein” (approximately 21 x 19 x 7 cm) but it is a little tricky to get all coins out due to the smaller hole diameter. Diagonally it fits perfectly on the print bed of the MK3S. Update: There is now a third version (approximately 28 x 25 x 8 cm) with a shorter trunk “Kurzer_Ruessel” to fit the print bed of Bamboo Lab printers.