About this 3D model

This is a simple piggy bank measuring 10 × 10 × 10 cm. The lid simply snaps on top and is held securely by four locating pins. To attach the lid, carefully snap each side into place by gently pressing the outer wall. There is a slot in the lid for inserting coins or folded bills. My short URL is embedded in the bottom of the base. Printing parameters: Layer height: 0.2 mm Seam position: Back Wall generator: Arachne First layer flow ratio: 1.05 Single wall on first layer: Enabled Wall lines: 3 Top shell layers: 4 Bottom shell layers: 4 Infill density: 10 % Infill pattern: Gyroid