About this 3D model

This print takes quite some time and uses a lot of material, but in my opinion it worth it. I spent a lot of time trying to fix the annoying wobbling issue using the stock carriage, before printing it. Now my carriage is solid as I always wanted. To assemble this, besides the hardware already on the stock carriage, you just need: 4x M3 washers 4x M3 x 14mm bolts (or a little shorter). Longer than 14mm won't fit. Washers and bolts are only to assure the legs will be held firmly in place. Not sure if it's even necessary because everything is very tight, I had to carefully hammer the legs down with a mallet, but I recommend, just in case. Also chech this: Vertical X Carriage and Vertical X Carriage (w/ eccentric nut) ===== If you'd like to support me you can post a make, comment and/or pay me a coffee at PayPal