About this 3D model

Allows ASUS ZenWifi MESH Network nodes (XD5 AX series) to be positioned outside and protected against the elements. UPDATED: OCT 24 - Updated model design v5 - Both parts now print with ZERO supports needed, faster NOV 25 - Updated Base model now much stronger JAN 26 - Remix model added - MAGNETIC attached base (requires (24x) 10x5mm round Neodymium magnets) Slide 8 magnets into each of the 3 channels and press seal each with a stopper. (Recommend printing in ASA filament for UV protection) Note: A 10mm rubber grommet or some electrical tape is recommended for the bottom hole for the power wire, so as to stop spiders etc. getting inside. Also; Related model; https://makerworld.com/en/models/151550#profileId-165448