About this 3D model

This model has been carefully designed to look great with 8 colors. Only filament swaps! No AMS necessary. Instructions : This is a large print : 200 x 250 Make sure you wash your build plate with soap water and use glue stick/ liquid glue before printing. The adhesion will need to be on point. If you have and X1C, the print will overlap with your calibration lines. Either manually remove the lines just before the print (pause if you have to) or let tit print over and scrap it off later. It will not affect performance and will not be seen. This does not need an AMS to print, but it does make it easier. If you have an AMS, print directly from the provided print profile. If you don't have an AMS, open and slice in the Bambu Studio app and add pauses at the provided layer heights for filament swaps. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm Swap Instructions: Start with Black At layer #8 (0.8mm) swap to Brown At layer #10 (0.96mm) swap to Red At layer #12 (1.12mm) swap to Blue At layer #15 (1.36mm) swap to Green At layer #18 (1.6mm) swap to Yellow At layer #20 (1.76mm) swap to Blue Light At layer #22 (1.92mm) swap to White for the rest.