About this 3D model

Mounting bracket for Ubiquiti Unifi APs. It should fit UAP-AC-LR, UAP-AC-LITE, and UAP-NANOHD. The mount included with these APs requires punching holes through the ceiling tiles. This bracket can leave the ceiling tiles without noticeable damage when the AP is later moved or removed. This is a remix, with the following changes from the original: Trimmed and re-spaced the clips to allow straddling a cross piece in the grid between the two clips. Rotated the clips to fit in line with the fullest part of the bracket. Added heat vents based on concerns I saw here. Added 1 mm additional clearance between the bracket and the ceiling, so the heat vented from #3 has somewhere to go. Changed the ends of the clips to fit easier on the grid without scaling. My first attempt with the original clips would not go on. The altered clips are still _very_ tight. Reduced the overhang angle on the locking tab Rotated the part to point the locking tab towards the user by default. This should make removal from the print bed easier for right-handed people on most printers. Model Options There are two models included with this thing, each with both a .stl and a .3mf file. The "_extended" model is intended for use when you have ceiling tiles with trimmed edges to hang below the grid, and it extends the mounting clip an additional 6 mm from the plate.