About this 3D model

I don't typically share Political or Religious Models. I try to stay away from Politics in general, as they are all corrupt, but recently my social media algorithms have been hijacked by the Epstein Files and all kinds of craziness that has opened my eyes to the world we are living in but I think it's all part of their plan to try to instill fear. I have had numerous requests for a little Bible fidget and I have really been thinking more about it lately so here is my version of a little Bible fidget with the most mentioned phrase in the Bible "DO NOT be afraid". Just a daily reminder for anyone who may need it in. There is also a blank page version attached for a custom passage. __________________________________________________________________________ I highly recommend using the 3mf files as the models are pre-colored and presliced for the magnet pause. I printed these models on the Snapmaker U1 at a 0.20mm layer height. and they turned out beautiful. I used the top surface iron setting (Same Ironing Setting I used on the cassettes) The 3mf file will pause the build at layer 18, at which point you insert your magnets into each side. Simply place (8) 8x3mm magnets inside each half, don’t forget to reverse the magnet polarity between the two halves. I found it easiest to place them inside the holes while the magnets are stacked up and then just slide off the stack once each magnet is dropped in place. Video of magnet insertion (different design, same process)...https://www.patreon.com/posts/kickflip-magnet-121228896?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link. After all magnets are in place press resume and wait for the printer to finish. The magnets I use can be found here…. https://linktr.ee/mzmdigitaldesign. Please note if different magnets are used your fidgets may not function as intended. This Fidget was printed on a Snapmaker U1 with the standard 0.4mm nozzle and printed at a 0.20mm layer height. SUPPORT & BRIMS are REQUIRED for the outer edge for this model, which are already set within the 3mf file. The fidgets move best when printed on the standard textured PEI build plate. Ensure you have good bed adhesion. I found a light grey material to be better than white for the pages. Please let me know if you have any questions. Thank you! Mike