About this 3D model

Description This is the Kaby Lake Version of my simple delid tool. Thanks to "Stullen Andi" for sharing the CPU dimension source :) This Version is BETA, I dont have a Kaby Lake CPU therefore it would be great if someone can print, test it and give feedback if it will fit This tool should also work with Skylake/Devilcanyon/Haswell CPUs as Kaby only has two additional noses. * print both parts, * put some sort of rubber or foam on the inner bottom of the base. * put the CPU into the CPU-holder with the long PCB part looking over the end of the tray. * then put it in your vice and close it slowly carefully (giving the glue time to release). For enough strengh print at least with 3 perimeters and 30% infill ! USE AT YOUR OWN RISK !!! * Only for CPUs who are glued and with thermal-paste, not for soldered CPU`s Donation: paypal.me/chriyoumagine Materials and methods Some sort of thin foam/rubber A vice. - do NOT use a screw clamp (c-clamp) or a hammer ! a 3D printer that can print very exact, the dimensions are very tight to ensure that the cpu won`t jump out while pressing. From the responses until now it seems that the glue of the Kabylake cpu`S may be a little bit stronger, so its strongly recommended to print with high-impact material like PLA at 0,1mm layerheight or less and very high infill !