About this 3D model

Curved and skinny brother of https://www.myminifactory.com/object/3d-print-148013 It's a risky one. Print if your printed is well calibrated since dovetails on this one does not have much tolerance for fit.Adding their photo side by side for comparison. A dab of super glue or generic clear glue like UHU in the tails would be helpful. It can accommodate longer strip than other model mentioned above: 60 vs 50cm Center of mass was calculated to be on the stand center. It doesn't have magnet slots under the stand unlike the other version. Printing tips: Since it's long and skinny, I recommend dropping anti-warping brims to the ends https://www.youtube.com/watch?v=D45eIhoWSyg Stand should be printed sideways for stronger mounting point for the post. It will require support anyways.