About this 3D model

Every now and then I ride with a navigation system (TomTom Rider 550) on my KTM SMC-R (2019). Unfortunately, the original TomTom mount looks awful and is also very high. I'm also too lazy to completely remove it every time I ride without the TomTom. That's why I decided to design my own mount, where you can easily and quickly remove the holder of the TomTom navigation system and where the navigation system sits a little deeper and more centrally. Simply slide a plate into a base carrier, which remains on the motorcycle and secure it with 2 thumbscrews. Then plug the cable together and you are done. The whole thing only takes a few seconds. In addition to the printed parts, you also need: 2 countersunk screws M3x16 (for the locking screws) 2 nuts M3 (for the locking screws) 2 threaded inserts M3 (for the locking screws) you can get them from Ebay or Amazon 4 cylinder screws M6x60 4 nuts M6 Every now and then I ride with a navigation system (TomTom Rider 550) on my KTM SMC-R (2019). Unfortunately, the original TomTom mount looks really shitty and is also very high. I'm also too lazy to unmount them completely every time I drive without the TomTom. That's why I decided to design my own mount, where you can easily and quickly remove the holder of the TomTom Navi and where the navigation system sits a little deeper and center. Simply push a plate into a base carrier, which remains on the motorcycle and secure it with 2 locking screws. Then plug the cable together and finish. The whole thing only takes a few seconds. In addition to the printed parts, you also need: 2 deceit head screws M3x16 (for the locking screws) 2 nuts M3 (for the locking screws) 2 threaded inserts M3 (for the locking screws) you can get it from Ebay or Amazon 4 cylinder screws M6x60 4 nuts M6