About this 3D model

Hello, and again, welcome to the Tomtom Science Companion Cube kit card puzzle. We hope your brief print in the printing vault has been a pleasant one. Your print has been processed and we are now ready to begin the test proper. Before we start, however, keep in mind that although fun and learning are the primary goals of all print kit cards, serious fail-prints may occur (jk). For your own safety and the safety of your printer, please refrain… …to change any settings on the model. (But you can if you want.) Boost Me If you like my work, feel free to give me a Boost. It doesn't cost anything, and it helps me create more awesome models. The instructions will begin in three… two… one… Chapter 1: The Clipping Call Remove all parts from the Kit Cards either by breaking or cutting them out. Chapter 2: The Cool Fit Put the pins in the indented side of the gray wall piece. Chapter 3: The Real Turn Lay the cross-piece on top of the gray wall piece. Gently and evenly press one tab after the other in. Chapter 4: The Suprise Click Press the Heart-Center down as far as possible, then press the four tabs down until they click in place. Chapter 5: The Edgescape Add the Corner Pieces to the corners of the gray wall piece Chapter 6: The Fun Repeat the process six times. Chapter 7: The Reunion Put four walls on the Cross-Piece and one on the Supporting Stick Piece Chapter 8: The Stick Push the Supporting-Stick Piece gently through the Cross-Piece. Chapter 9: The Part Where He Loves You Congratulations! You now have a Companion Cube. Please note that the Companion Cube cannot speak. If it does, its advice should be ignored. This time, try to take good care of it. Can be put together entirely without glue. Please mind the tolerances - I have made two different sizes. In my case I printed the 60% one using DRIED Bambu Lab PLA Basic. If something didn't fit just let me know and I'll take care of it. There are two different versions depending on whether you print with an AMS or not.