About this 3D model

A nine pot multi tier planter, perfect for a windowsill or table! All pots drain into the center section and collect in the bottom. Excess water can be left in the bottom to add humidity or can be drained by tipping it slightly. The pots are 6cm wide - Perfect for 5.5cm Cactus and Succulents Print Settings: Layer Height 0.2-0.3mm. No support or infill required! 5 top/bottom layers 3 perimeters Designed and tested to print in place really easily. Make sure your bed is level before printing - If it isn't then you can run into issues many hours into printing. It takes roughly 18-24 hours to print, depending on layer height. Thanks for looking and please upload pictures of your creations with this!