About this 3D model

List of hardware needed: Towerpro SG90 servo motor RC servo motor tester LED strip 5v Tactile button - 15mm height Terminal block Brass threaded insert m3 m3 screws - 6mm & 10mm Lithium Battery 18650 3.7v - make sure to use 2500mAh or higher battery.. or its not going to be enough to power all servo tester and LED Lithium Battery 18650 holder TP4056 - USB to lithium battery protection & charger module Rocker switch - 2pins 15x10mm wires.. glue gun.. soldering gun.. Wiring diagram: the turrent will be turning using SG90 servo motor.. we will be using the servo tester to control the SG90 servo.. there are 3 modes.. manual control.. servo centered.. and looping turns… since the servo tester board will be use to control manual movement of the turrent.. we will need to solder a new tactile button to control the modes of the servo tester.. everything is powered by a lithium battery connected to a USB charger I made the servo motor loose because it seems there is a variation of the SG90 and the size is different.. so i made bracket to be screwed on to hold the servo.. once all wiring is done.. you'll need to make the LED screen.. i made a simple 3 line LED strips and wire the +ve and -ve respectively.. the wire is long enough to reach terminal block Insert the LED screen and screw it in place.. insert the frame.. text signage and the yellow screen in sequence and screw them together into the base.. And you're done.. I hope you'll have fun making this deathstar signage..