About this 3D model

DIY filament dryer based on ECG SO 375 food dehydrator. There are two options for PTFE bowden tube mount: bowden-mount_lid.stl - not very convenient bowden-mount_base.stl - recommended, much better You will need ECG SO 375 food dehydrator Lamart LT6036 cake box 51208 thrust ball bearing (inner diameter 40 mm, outer diameter 68 mm, height 19 mm) 1/8" pneumatic fitting PTFE bowden tube (standard 4/2 mm) 4× M3x8 screw + 4× M3 nut (when using bowden-mount_lid.stl ) Print and assembly instructions use PETG for better heat resistance print 4-6 pcs of wall-adapter.stl drill a few holes in the top of the lid (two is enough) cut a hole in the lid for the bowden mount, 17 mm wide and 11 mm deep (when using bowden-mount_base.stl )