About this 3D model

3 parts riser that allows to avoid overhearing especially PLA filament when they are dried. There are 2 types of riser. original with a straight part in the middle fixed with a little bend in the middle to allow drying full spools I tried all of my filaments and everyone fits in but there is a small amount of space between the top and spool, so if you have a problem, let me know, and I will make it a little bit smaller. Print Settings I used PETG and it's holding up fine. You could use ABS or ASA if you are concerned about heat warping. I printed it in standard settings, 15% infill, with support, on the side, and it comes out nice, but you will maybe need to make a thinner layer height. Even after using the riser, I don't raise the temperature sensor, based on measurements from the bottom of the dryer, it is a good placement for this built-in sensor. Additional tip: If you see that temps are too high you can move the temp sensor a bit, to expose it to hot air. With this, temps on the bottom of the spool are almost exactly like set on the dryer . Checkout my profile for more models: https://makerworld.com/en/@AngryPearl Boost Me Boost me for new, similar models. You can also suggest ideas or improvements that I can implement