About this 3D model

A 26mm spacer for the lid on an Eibos Cyclopes drybox. This allows you to route the filament through the spacer instead of the lid making the lid simple to remove. I truly hated the original design when using two spools. BOM: -printed spacer, must be printed in ABS/ASA to prevent warping when drybox is heating -two M3 threaded inserts (Voron spec) -two M3x8 screws -two PC4-M10 pneumatic fittings Two 3mm holes need to be drilled on the drybox if you wish to mount the spacer with screws. Not really necessary though :) Fits on a Bambu print bed and prints beautifully in three hours.