About this 3D model

Holder for Festool guide rails, also fits other manufacturers if the lower part is constructed differently or if you accept that it does not fit perfectly. Simply screw it to the wall and mount the upper snap-on part close enough to the top edge of the rail so that you can remove and reinsert the rail. After printing, you need to loosen the upper holder forcefully once so that it can move back and forth. --------------------------------------------------------------------------------------------------------------- Smart guide rail holder for any Festool or other compatible rails. Just mount it to the wall and place the snapping holder just tight enough towards the top of your rail so you can pull it out and snap it back in. After printing, push the top holder very hard so it breaks loose and can move back and forth.