About this 3D model

Hey everybody, one of my other hobbies is photography and I've got an fine art Printer which prints up to A3+ format. Since I change the pictures on my wall quite regularly, I wanted a simple and quick solution to put my pictures on the wall. If you are the same, look no further. Here comes the ultimate Photo / Picture rail Features: Its available in different sizes: A4 portrait (20cm) A4 Landscape/A3 portrait (30cm) A3 landscape (42 cm) The 42cm version is suitable for the 48cm wide landscape format of A3+ too. Works like charm. Strong grip. You need 5mm x 2mm round magnets. The cheap ones on amazon are strong enough to hold an A3+ sheet of 300g FineArt paper. good compromise between low profile and stability How to print: just slab it onto your build plate, print with standard settings the two smaller ones consist of two parts the big one has 4 parts if you have adhesion problems especially on the edges of your build plate, I recommend adding a brim or mouse ears. How to assemble: the hinge is not print in place you need to push a small strip of 1.75mm filament into it if the holes are to small, its most probably because of the z-seam. Just use a small round file or a rolled strip of sanding paper to make it a little bigger glue in the magnets with super glue (make sure to have the orientation correct) for the 42xm rail: glue together part 1 and 3 and part 2 and 4