About this 3D model

NOTE There are now two folders for the STL files one for Kapex versions before 2025 and one with new versions manufactured in 2025 and later as there are likely slight differences in the cast table Festool Kapex 60 hold-down clamp for KL-KS 120 clamp This allows you to use the clamp which normally only works for the Kapex 120 on a Kapex 60 as well Simply screw it on from below through the existing hole with an M8 screw on the miter saw base It is best to print with a high-quality filament such as PC ABS or carbon fiber-reinforced filaments to withstand the forces of the clamp without breaking May 13 2023 Updated version without print support and with more stability April 23 2026 Divided into two folders with versions before 2025 and current versions manufactured in 2025 and later Additionally a variant with more tolerance for the clamp shaft is included in case the printer prints the hole too small or the material used shrinks excessively