About this 3D model

Click-snap assembly (no glue, no bolts). Can be taken apart afterwards.Designed to be printed with 0.6 (or smaller) nozzle at 0.2 layer height, no supports needed. Don't forget to reduce the layer height if you plan to downscale it. Printed well at 50% scale with 0.3 nozzle at 0.1 layer height, was a bit tricky to assemble though. This little van can serve as a piggy bank with one of the roof inserts. Explosion diagram in 3d viewer (Sketchfab): https://skfb.ly/6Wz7S 10x10x6cm, 70g.