About this 3D model

This set hat 6 3D Druck pieces to build 2 Axis Solar Tracker. You need 4 parts ball-bearing-6x3x2-5.stl and only one piece all other parts. If you need my Firmware with digital filtre for each axle you need pay for this 15 €. If you don't want pay for Firmware - you can find it in Internet in many variants. For building i used 3 60x60 mm photvoltaik plates, 2 SG 90 Servos, an Arduino Uno plate, an Arduino UNO MEGA Duemilanove Sensor Shield V4 Digital Analog Module Servo Motor, DC-DC Converter, 4 Photo Light Sensitive Resistor Photoresistor Optoresistor 5mm GL5528, Screws and plexiglass plate 150x200 mm. I used as inspiration https://www.browndoggadgets.com/products/dual-axis-smart-solar-tracker this tracker, but wanted make it easer and 3D printable.