About this 3D model

[Introduction] This is a version of my sci-fi case, sized to work with the [BaBo] system (8x6 units → Willi 3D's BaBo Collection). I liked the insets! The prototype versions of this case I've already been using to hold printer tools, and so it just seem natural. They work and look great together. [Printing Info] It's a tight fit on build plate! I recommend printing the case portion with some sort of support to help the curves print nicer. [Hardware & Filament] Featured Filaments: Polymaker Polyterra Muted White Bambu Matte Charcoal Bambu PLA Basic Bambu Green Hardware: (Full disclosure, I am part of the Amazon Affiliate Program. All amazon links are affiliate links. I earn a small commission from these links without any added cost to you. These links help to support me so I can bring more content for free! A general M3 Assortment kit, such as such as this one from Amazon US will work and help provide screws for some of the other projects I offer! Wink wink.) 16x M3x10mm Screws (Like these from Amazon US ) 4x 4x6 Round Bar Magnets ( Here's a few sources! Amazon US 1 , Amazon US 2 , SuperMagnets , Apex Magnets ) A piece of filament for the hinge! [Assembly] Assembly should be fairly self explanatory. Screw the end plates into plate, except for the hole where the hinge will be. Position the lid onto the body, insert the piece of filament to use as a hinge pin, then screw in the final screws to secure everything in place. ------- If you like my work, consider showing your love by Buying me a coffee . Additionally, if you're looking to sell prints of my design, please check out my Patreon page for more information.