About this 3D model

This is a 70mm deep desiccant tray that will fit inside a print dry pro 2 or 3. I created this model because this dryer can dry a lot of spools at once and I also like to use desiccant inside my AMS which needs a large amount to be dried. Suggested to use ABS or ASA if you're going to be drying above 55*C for long periods Possible to use PLA+ or PLA Tough (I printed the prototype in PLA Tough) The bottom is 6 layers and the walls are 4 The prototype print was in ludicrous mode using PLA but obviously will need to slow down for ABS Please like and share photos of your completed trays!