About this 3D model

【Introduction】 A floppy disk-shaped SD&TF card storage box that can hold up to 4 SD cards and many, many TF cards I designed the lid as a floppy disk stand, with two angles, transforming it into a small desktop ornament Assembly design, no AMS required Perfect for a small gift for friends, you can customize the name on the model in the slicing software (ps: English is easier to print) Hope you like this cute little design 【Printing】 I tested using petg Remember to modify the preset configuration to match your printer and material The printing difficulty lies in the fact that the top of the model is prone to warping , pay attention to applying glue to the bottom plate, or use other methods suitable for your material to prevent warping (adding a brim will affect the finished product, not recommended) The default setting is 100% infill, as this improves warping and makes it more substantial and textured, but you can change it to the default infill Some parts of the model that are suspended may have defects, most of which are invisible after assembly, defects that do not affect assembly do not need to be dealt with, the rest can be trimmed off Assembly is very simple, remove the supports clean, the round piece needs to be glued, and the other components are snap-fit, very strong If you don't have AMS, print it in separate parts, or use acrylic markers to color it 【Other】 This floppy disk is not the real 3.5-inch floppy disk size, but I think this size is very cute in the hand, so I didn't change it In the future, I may slightly modify the overall size and the layout of the internal card slots, because now I don't know what to put in the bottom space, unless there are so many TF cards that you can't count them with one hand The f3d source file is also released synchronously, you can create your own derivatives, welcome to follow me on Bilibili @鱼小兑Yo, I will print more of my own works to draw for everyone in the future, thank you for your support~