About this 3D model

Reduces poop pop out to ZERO! UPDATE!!!!! Version 2 is UP! After feedback, I created a V2 with a U-SHAPE wiper lip! Should be printed best in ABS or ASA. PETG is ok too. PLA might get soft if printing ABS or ASA a longer time… Also see my Poop PoP Stop with A1-Brush Remix https://makerworld.com/models/133344 -------------------------------------------------- Using the Poop Pop Stop in a long print with many filament changes I saw a few problems. The Stopper works, but the hole under the nozzle was too small. Sometimes the hot chute got stuck at the stoppers wall and blocked the hole, leading to even greater mess! Especially BVOH or PVA. So I made the hole a little bit bigger by cutting it into the model. After success, I created this remix! -------------------------------------------------- Best to print in ABS or ASA. PETG is also OK. PLA may become soft if ABS or ASA are printed for a longer time. After using the original Poop Stopper in a long print with many filament changes I noticed some minor problems. The Stopper works, no question, but the hole for the nozzle is too small. Occasionally, waste gets stuck on the Stopper itself and blocks the hole, leading to a bigger mess, especially with BVOH or PVA. For this reason, I modified it. The hole for the nozzle is now bigger! NOTICE: THIS IS A SIMPLE PRINT. AS YOU SEE IN THE PICTURES, MY MODEL STICK VERY GOOD ON THE BED. SO BEFORE YOU GIVE BAD RATING TO MY PROFILES, BE SURE YOU HAVE A GOOD BED ADHESION AND ASK TO YOURSELF, WHY YOU DON’T HAVE A GOOD BED ADHESION. I DON’T WANT TO UPLOAD A LOT OF PROFILES FOR EACH SINGLE PROBLEM YOU HAVE AND FOR EVERY SINGLE MODEL! EVEN YOU WANT TO SHARE ONE, IT DOESN’T MAKE SENSE FOR THE SIMPLE MODEL ITSELF! PLEASE, LIKE I SAID THE MODEL STICKS ON THE BED EASY! NOT ALWAYS REDUCING THE SPEED CAN HELP YOU TO STICK EVERY MODEL ON THE PLATE! THANK YOU FOR THE UNDERSTANDING!