About this 3D model

M-LOK Rail Covers Sizes 1, 2, 3, 4 relate to number of M-LOK slots that the rail or handbrake occupy. Short versions can be stacked one next to another. If you prefer “standard” version, check my other remixed model. I remixed the original version: reduced weight improved design - cut holes through the model, adjusted the angle in holes for screws added one extra hole in the middle of the rail cover for better look and durability If you prefer the standard "not short" version, you can check another model - long versions have slightly extended ends, primarily to be used as a single cover. LINK for “longer” here: WIP Print settings: resolution: 0,20 mm or better infill 30-40% no supports 4 bottom layers avoid crossing walls (not required, but it could help a lot) arachne wall generator grid infill material: PLA/PETG/ABS (PETG or ABS recommended, but PLA is usable too) Hardware: You can buy original M-lok nuts and screws. However, you can also go on a cheaper way, check below: M4 2020 series sliding T-nut M4 10/12mm flat head socket countersunk bolts screw