About this 3D model

Sling Kontrol - MLOK "by" Qwerm A shameless ripoff of Subrev's M-LOK Sling Control, a M-LOK accessory that helps store your sling when not using your rifle. Print orientation: Print everything on it's side. Settings used: Layer Height: 0.2mm Wall Line Count: 4 Infill Percentage: 100% Support: None Fuzzy Skin: On Fuzzy Skin Outside Only: On Fuzzy Skin Thickness: 0.1mm Fuzzy Skin Density: 10.0/mm Materials Needed: 1/8 Inch Shock Cord 2x M3x8 Screws 1x M-LOK Mounting Screw and Nut Directions: - Mount the larger part to your M-LOK slot. - Cut a length of shock cord and feed it through the larger part. - Insert both ends into the smaller part - Screw in both M3 screws until snug enough to keep the ends of the shock cord from pulling out but not enough for you to strip out the holes. Credit to SubverTech for the design. For more info check out their website: https://subrevtech.com/product/sling-control-mlok/ https://subrevtech.com/instructions/