About this 3D model

The drawer part number is 2403547 from Frigidaire Gallery. Found out this drawer could cost me more than $200.00 so I designed a part that would stabilize the crack that formed in the center of the drawer. If I used the drawer again it would have been a write off. The part can be printed without supports with the open side down on the build plate I used a heat gun to get the plastic part that I printed warm so that the hot melt glue would not harden immediately. I then added the glue and pressed it in place. I drilled holes in the drawer where needed. It is easy to see where the holes need to be because of the clear plastic. Don't drill them too far into the plastic printed part. Use M3 screws to hold the part in place. They should tap into the plastic on their own and hold well.