About this 3D model

Hello Community Now a small but elegant solution for storing scrapers. It's simply clipped on. No screws or glue needed. As for the support variant: I have been printing with PLA support material and a PETG upper shell material for some time. (The cleaning volume must also remain 800) Settings are all pre-configured, you only need to set your filament and select the PETG. Very easy removal of the supports. I would be very grateful if you could give me a brief feedback on the solution. Have fun with it. Hello community Now a small but nice solution for storing scrapers. It's just clipped there. no screws or glue necessary. To that of the support variant: I have been printing with PLA support material and PETG top shell material for quite some time. (Cleaning volume must also remain 800) Settings are all prepared, you don't have to do anything except adjust your filament and select the PETG. very easy to remove the supports. I would be very happy if you could give me a short Featback on the solution. have fun with it.