About this 3D model

The original ( https://www.thingiverse.com/thing:5881751 ) intended for the Pi to be mounted on the back of the display. I wanted to have the display inside the housing for my Neptune 3 Plus, but the Pi outside. Therefore, I used the holes for the Pi and mounted a plate to the touchscreen with BTT-PITFT50_rear_mounting_plate_spacer and BTT-PITFT50_rear_mounting_plate, which can be reused modularly. With BTFT50_mounting_arm and BTFT50_mounting_arm_twisted, an arm can then be built that makes the display swivel. Since the original BTFT50_mounting_bracket was too short for me, I modeled a BTFT50_mounting_bracket_extended. With a few M3 screws and nuts, everything can be securely assembled. Enjoy the model!