About this 3D model

Easy to print honey spoon. No support needed. If you wish, you can also print without infill. I printed the prototypes from pla filament, but I recommend using a more heat-resistant filament. Don't leave the spoon in the hot drink though :D A word about design. I could have done the slanted thread upside down and printed the piece upside down as well, but I think the upward slanted thread works better because when using a spoon, the honey flows into the cup better. Even when stored on the table, the remaining honey does not drip and make a mess. However, there is a small dilemma here. The spoon should be clean when stored upright :) I hope you like this design and I hope you comment how this works for you. Thank you!