About this 3D model

his honey dipper is designed to fit in a standard jelly jar (or 8oz canning jar). Just replace the seal part of the standard lid that comes with the jar with this lid and honey dipper assembly. The tolerances for the stem and the lid are very tight, so I recomend using a standard kitchen can-opener-griper to help twist while assembling the parts. The fit is so good I haven't had to use glue to attach the two parts. If it is too tight of a fit you can either do a little sanding or print the dipper part a few percent smaller in size. Enjoy! Notes: - Use a food safe filament (I used MakerGeeks Raptor PLA) - To print the Bee on the top of the handle change color at 47.2mm. If you are printing the stem at the same time then just switch back to the original color at around 49mm.