About this 3D model

English Introduction This “Wire Spool for Electronics” is primarily designed for AWG 20 to 24 gauge conductive wires. Calculations using the Cable Reel Capacity Calculator indicate a capacity of approximately 55 meters of AWG 22 gauge wire (1.6mm width). The spool comprises two precisely fitted halves, designed with a 0.1mm tolerance gap to ensure a snug, inseparable connection. However, the final fit may vary depending on your 3D printing parameters; flow calibration is recommended for optimal results. Instant adhesive can secure the two halves. M3 locking attachment holes provide additional structural integrity. The only non-printed component is a crossbar under 14mm in length. A readily available 1/4-inch (12.7mm) steel pipe or wooden dowel from a hardware store suffices. Bill of Materials Stainless Steel Phillips Flat Head Screw, M3 x 0.5 mm Thread, 16 mm Long * 2 Stainless Steel Hex Nut, M3 x 0.5 mm Thread * 2 Chinese Introduction This “Electronic Wire Spool” is primarily designed for AWG 20 to 24 gauge conductive wires. According to the Cable Reel Capacity Calculator, it can hold approximately 55 meters of AWG 22 gauge wire (1.6mm width). The spool comprises two components designed for a snug fit, preventing separation with a 0.1mm tolerance gap. Note that the precise fit may be influenced by your 3D printing settings; flow calibration is advised for accurate results. Instant adhesive can be used to firmly bond the components. M3 locking attachment holes are included for structural reinforcement. The only non-3D printed component is a crossbar less than 14mm in length. A readily available 1/4-inch (12.7mm) steel pipe or wooden dowel from a hardware store will suffice. Bill of Materials Stainless Steel Phillips Pan Head Screw, M3 x 0.5mm, 16mm Stainless Steel Hex Nut, M3 x 0.5mm