About this 3D model

English Introduction This “Wire Spool for Electronics” is designed primarily for AWG 20 to 24 gauge conductive wires. Calculations using the Cable Reel Capacity Calculator indicate a capacity of approximately 35 meters of AWG 22 wire (1.6mm width). The spool comprises two precisely fitted halves, designed with a 0.1mm tolerance gap to ensure a snug, inseparable connection. However, the final fit may vary depending on your 3D printing parameters. Flow calibration is recommended for optimal results. Instant adhesive may be employed to secure the two halves. M3 locking attachment holes are incorporated for enhanced structural integrity. The only non-printed component is a crossbar under 14mm. A readily available 1/4-inch (12.7mm) steel pipe or wooden dowel from a hardware store will suffice. Bill of Materials Stainless Steel Phillips Flat Head Screw, M3 x 0.5 mm Thread, 16 mm Long * 2 Stainless Steel Hex Nut, M3 x 0.5 mm Thread * 2 Chinese Introduction This “Electronic Wire Spool” is primarily designed for AWG 20 to 24 gauge conductive wires. Calculations from the spool capacity calculator suggest an approximate capacity of 35 meters of AWG 22 wire (1.6mm width). The spool comprises two components designed for a tight fit, preventing separation with a 0.1mm tolerance gap. Note that the precise fit may vary according to your 3D printing settings. Flow calibration is recommended for optimal results. Instant adhesive can be used to securely bond the components. M3 locking attachment holes are included for structural reinforcement. The only non-3D printed component is a crossbar less than 14mm in size. A readily available 1/4-inch (12.7mm) steel pipe or wooden dowel from a hardware store is suitable. Bill of Materials Stainless Steel Phillips Flat Head Screw, M3 x 0.5mm, 16mm Stainless Steel Hex Nut, M3 x 0.5mm