About this 3D model

This TPU spool ring should increase the “GRIP” of the plastic spools. Some spools are very smooth and practically slip through. This then leads to problems, for example, when retracting the filament. To prevent this, the ring is attached on both sides. The first aversin is a ring with a size of about 200mm. This size fits most of my spools that I use here. 200mm fits the following spools: Bambu Labs 1kg AzureFILM 1kg S SIENOC 1kg Premium Select 1kg Spectrum Filaments 1kg Pusament 1kg More may follow! Print two overlays. One for each side! --------------------------------------- This is an rings for spools to enhance the grip in my AMS. Some dont roll in it, they slip, resulting in not correctly winding up the filament. After a few experiments, i constructed this solution. I enhances the “grip” of the spools, resulting fewer Errors! First release is for 200mm. Please give me possible lesser or greater diameters. I may try to add them. Most of mine are 200mm 200mm fits spools from: Bambu Labs 1kg AzureFILM 1kg S SIENOC 1kg Premium Select 1kg Spectrum Filaments 1kg Pusament 1kg More may follow! Print two, to outfit a spool! This work is licensed under a Standard Digital File License. NOTICE: THIS IS A SIMPLE PRINT. AS YOU SEE IN THE PICTURES , MY MODEL STICK VERY GOOD ON THE BED. SO BEFORE YOU GIVE BAD RATING TO MY PROFILES, BE SURE YOU HAVE A GOOD BED ADHESION AND ASK TO YOURSELF , WHY YOU DON'T HAVE A GOOD BED ADHESION. I DON'T WANT TO UPLOAD A LOT OF PROFILES FOR EACH SINGLE PROBLEM YOU HAVE AND FOR EVERY SINGLE MODEL! EVEN YOU WANT TO SHARE ONE , IT DOESN'T MAKE SENSE FOR THE SIMPLE MODEL ITSELF! PLEASE, LIKE I SAID THE MODEL STICKS ON THE BED EASY! NOT ALWAYS REDUCING THE SPEED CAN HELP YOU TO STICK EVERY MODEL ON THE PLATE! THANK YOU FOR THE UNDERSTANDING!