About this 3D model

Hey there! This piece is a support I designed specifically to hold a pole of filament spools inside a dehumidifier box. It's super handy for keeping everything organized and protecting your 3D printing materials. A simple yet effective solution to optimize your printing setup! Two lateral angles for the firmness and one in the lower part for the support. Added an extra support at the bottom to help support more weight. Round out a lot of the support because it had to withstand spools and I did not want the edges to slow down the spool 20mm Pole 6mm Screws Print Settings Designed in: Fusion 360 Printer brand: MakerBot Printer: MakerBot Replicator+ Rafts: No Supports: No Resolution: 0.1 Infill: 10 Notes: It depends on whether you need to support a lot or little weight. With 10% and thanks to the support added below is enough.