About this 3D model

Chompy, The Filament Shark cuts the ends of your filament leaving a nice 40º shark bite across the end of the filament. Chompy doesn't leave filament ends everywhere, and has a big stomach for holding many filament ends. When Chompy is full, just lift the (magnetically latched) fin to let it poop all the waste filament into the bin. This is a relatively simple print. If you can print the card box, this should be easy. No support required. You can see Chompy in action here: https://www.youtube.com/watch?v=lVJGpDeQzrk You need: 2x 10mmØ x 3mm thick magnets 30mm m3 nut and bolt 12-16mm m3 nut A spring, around 5 - 6.5mm Ø and 15-20mm long. A 9mm box cutter blade - available from most hardware stores (e.g., https://www.amazon.com/Amazon-Basics-13-Point-Carbon-Blades/dp/B08D9Q796F). A dab of superglue in case the blade is a bit thin and doesn't want to stay in place.