About this 3D model

I very much liked the riser design of Marwyn. I wanted some changes though. For instance, I wanted to use a 10mm LED strip instead of the LED ramps Marwyn designed. I also wanted to avoid soldering the strips when installing them. So I created this remix. Hope you like it :) Here's what I have changed: Raised the upper surface (on which the glass rests) and the rim 2mm from the already raised frame of Marwyns model Changed the champfer on the inside above the vents from 55 to 45° and changed it's width to 10.5mm to accomodate for a 10mm LED-strip Created cavities in the corners to avoid having to solder the LED strips there. Simply stuff the excess strip in there Changed the holes on the inner flanges to accept M3 heat set inserts Created slots on the vents to accept TPU gaskets for a better seal when closed Created said gaskets for the vents Split covers and handles to be able to have the front surface of the covers printed on the bed for a nicer surface. The handles accept M2 heat set inserts and skrew on to the covers Recreated the 3mm top lid gasket featuring a shade to shield your eyes from the bright LEDs when looking through the top glass. BOM: 12 M3x8mm Cylinderhead skrew 12 M3 heat set insert 12 M2x4mm or M2x8mm Cylinderhead skrew 12 M2 heat set insert 48 5x3mm round neodym magnets 10mm LED strip I printed mine in Spectrum ASA-X CF10 for the frame and 3DJake ASA for covers and handles. Have fun!