About this 3D model

This is my take on Snap-on's excellent (but expensive) soldering clamp . Allows two wires (or LED strip) to be held in place with the spring loaded clamps. The knob allows you to move wires closer/farther apart without repositioning in the clamps. Assembly notes: Relatively easy to assemble (no glue or anything required). See cover image for general assembly. Put the springs in first. They intentionally need a bit of force , you are best off using something small with a blunt end to push the top of the spring into it's slot (something like the end of a hex wrench, handle of a ratchet or the back of a small screwdriver). Then Spring covers (each side is different… look for the holes where the clips slot into). Clips go on next (the part that look like small wheels). Be aware they intentionally don't spin (the connectors are square, not round, so look at the positioning… don't just jam them onto the peg thinking they will fit however). Screw goes in the small housing body and will slide into place to clip into the large housing.