About this 3D model

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. 200mm x 200mm. You can complete this print without an AMS. Use the profile that says NO AMS and it will pause at the correct height instead of doing a filament change. At that point you change your filament and let it continue until the next pause where it will wait for the next manual filament swap. This being a four color Hueforge, it will require three pauses with manual filament changes. Filaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA+ Sunlu Grey Transmission Distance: 2 PLA+ IIID Max Space Gray Transmission Distance: 5 PLA+ Sunlu White Transmission Distance: 5 Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Grey At layer #34 (2.8mm) swap to Space Gray At layer #43 (3.52mm) swap to White for the rest.