About this 3D model

This is the swing lid to fit onto the newly released “ Waffle Trash Can ”. There is not a lot to say about this; apart from it swings, it is an easy and quick print, and it looks great as well! This is a great little bin for the bathroom, kids' room or even on your office desk. There are now 3 bins in this series - find them all on my profile page. Instructions: Print it (single plate) Remove the brim from the base of the connector pins. Remove the support material from outside of the main frame. Most of this should come off pretty easily, but a little cleanup on the underside edge may be required. Insert the first connector pin WITH THE WIDEST SECTION going into the hole. Add the swing lid onto the pin From the underside, insert the other connector pin with THE WIDEST SECTION going into the hole first. As always, please be sure to share some photos with all of us here. A great comment and review would be appreciated, too. Thank you very much.