About this 3D model

Yet another filament clip. Rather than twist or contort the loose end of your filament to hold in-place by hole locations on the reel, this clip provides a simple way to clip and un-clip the loose filament during storage. The clip fits onto the edge of the spool reel. The clip has been optimised for a spool reel with a 4.0mm rounded edge and tapers away from the edge, as implemented on the 3DFillies filament brand. Other filament brands may fit well, too (there are so many brands!). In most cases, you can leave the clip in position on the reel whilst printing. It's tiny, at only 10mm high. The filament facing side is angled to avoid the spooling filament and not get snagged. The filament lightly snaps into place, but holds well in storage. I've printed the clip in both PLA and PETG, but found PLA showed cracking, so I'd recommend PETG. My print is made in PETG 1.75mm Aurarum white filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer. I hope you can find this print useful, too. Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.