About this 3D model

INTRODUCTION I have been searching for a simple riser for my X1C, no light, simple, fast and easy to print. Found the design by krazyderek, and I added Ø6x3mm magnets to improve the hold on the X1C metal frame. The original designer allows remixes, so don't go report license infringement before doing due diligence. I have also included these step files of my remix. BOM Ø6x3mm magnets - 14pcs (18pcs optional) INSTRUCTION single plate print. no support is needed. I use PLA. It's a riser to vent the enclosure heat, so it not going to get hotter than 40C. Takes around 2.5 hrs to print. Magnets are press fit. Holes are designed to be Ø6.1mm with chamfer. It's tight-fitting. I use a rubber mallet to tap the magnets in. There are 2 optional parts for the front and back. CAVEAT As with all my designs, Prototyping and testing were conducted to ensure printability and meet my own expectations. However, I understand it may and may not work for you. I would request that you read all instructions and print and install them at your own discretion.