About this 3D model

This is a toy for cosplay or display purposes only! Never brandish this as a real weapon or bring it out in public, this is a toy modeled off of a REAL LIFE firearm, treat it as such. Just because you know it's a toy, doesn't mean other people will. Enjoy, be safe, and be smart! The BB-MPK is a functional prop/launcher and the unofficial (PLAS)TEC-9 V2. It is not a very powerful launcher, but still some good fun! Tolerances are quite tight in some places so sanding/filing may be required, but for best performance sand down the bullets and the barrel to reduce friction There are two super cool remixes on Printables by Katfish Heavy Industries, I would highly reccomend checking out. Silencer - Little Brew Boy - MPK: Silencer Mods by Katfish Heavy Industries | Download free STL model | Printables.com Overhaul of the upper reciever - Little Brew Boy - MPK: Upper Reciever Remix by Katfish Heavy Industries | Download free STL model | Printables.com My Settings: Printer - Bambu P1P Filament - eSun PLA+ (Black, Red & Silver) Walls/Top/Bottom: 4 Infill: 15%+ Supports: Required for larger frame parts. Printed Parts: 1x Lower Frame 1x Upper Frame 1× Bolt 1× Bolt Spring Rail 1x Bolt Latch 1x Trigger 1x Charging Handle 1× Barrel 1x Barrel Ring 2x Back Plate 2x Side panel (mirrored) 2× Grip Panel (mirrored) 1x Magazine Catch 1x Magazine 1x Lift Table 1x Magazine Spring Guide (Base) 1x Magazine Spring Guide (Joint) 1x Magazine Baseplate 10x Bullet Additional Hardware: 6x M3*5 Bolt 2x M3*7 Bolt 4x M3*25 Bolt 1× M3×20 Bolt 1× Spring for bolt (OD: 10mm, WD:0.8mm, length: 85mm) 1× Spring for Magazine (OD:10mm, WD: 0.6mm, Length: 150mm) 2x Pen Spring (1 for Magazine catch, 1 for Bolt latch) **Bolt and Magazine Spring were purchased off of AliExpress, I purchased a 305mm one of each wire diameter and then cut it to length. Tools: Needle nose pliers.(for pesky pen springs) Super glue. (To secure side panels) Hot Glue (to secure barrel)