About this 3D model

EDIT: V2 uploaded. improved airflow. I need to improve the VRM cooling in order to put a 20 core Xeon (E5-2673-V4), I'm already using a 16 core Xeon (E5-2683-V4) in this board without any cooling and the vrm cooler was very hot. My board is a Qiyida x99 ED4, but other boards has the same VRM cooler, this mods has compatibility with. Qiyida X99 ED4 Kllsre X99 V201 Machinist X99 PR9 Atermiter X99H Wovibo X99H You can check on youtube, these boards achieve 70ºC-80ºC of heatsink temperature with CPU's with 120-135W tdp stock with little/no airflow. This print you can fit both orientations, use the best can fit you in your combination with your heatsink/case. BOM 4x M3x12mm screws (you can use M3x14mm) (in photos used M3x12mm) 4x M3x18mm screws (you can use M3x20mm instead, used this in photos) 2x M3x25mm screws (M3x30mm screws in photos) 2x M3x5 heat insert 8x M3 hex nuts 2x 40mm fans (used GSDTIME 7500rpm 24v that I use in my voron, with 12v input produces good airflow without to much noise) Printing Avoid PLA, ABS/ASA recommended. I think PETG can withstand but definitely not recommended. 4 perimenters at least Print V2