About this 3D model

Boost Me You like the Design? Consider using your boost tokens to help and support me for free! - Want to earn easy reward points? Rate the print profile by going to the Rating link on your Profile drop down menu. - My own link is https://makerworld.com/en/@neocrisis/rating Summary 1/19/20 I added the image which is curved which makes it much more stable while printing. Yes, It is curved but it print comes out 100x much better than a straight print and honestly, putting them side by side, you cant tell the difference Additionally, you are able to attach this image a night light. Here is a lithophane for anime series Attack on Titan / Shingeki no Kyojin. It has a 3mm thickness and a 3mm border around it. My printing dimensions; height is 75% of width Thus, if the width if 120mm, then the height I use would be 90mm. I like printing my pictures standing up, I personally think it looks better. I tried printing a image flat....it looked very very bad. I personally will not try it again. I suggest using 100% infill to remove as many air gaps as possible, you do not really use much material anyway. You should use a brim to print this, I tried a raft but because the image is tall, it was not able to stand up straight and the print failed. I am the owner of https://www.neocrisis.com