About this 3D model

I would suggest PETG at 0.2 layer height. Differences of the remix compared to the original I have changed most of it to be honest, its longer at the bottom with vents, I have changed the power button. Its taller to support the Pimoroni board, has a thinner cable slot and a fan protector. I have removed the holes for screws and made it clip together. Hope you like it! 29/03/24 Waveshare PoE Hat Support I have added 2 files to support using the Waveshare PoE Hat for the PI 5 ! you will need the following: pi5_case_top_gpio_open_widedoor_POE.stl pi5_case_top_gpio_widedoor_POE.stl pi5_case_bottom_ssd_gpio_widedoor (Existing file) 02/03/24 RaspBee 2 Zigbee gateway Suppor t I have added an extra file pi5_case_top_raspbee_II.stl to support using a RaspBee 2 Zigbee gateway. It adds an extra 8mm to the top of the case and should be used in conjunction with pi5_case_bottom.stl - This has not yet been tested to fit as it's an ongoing request but I will confirm once user testing has completed. 12/02/24 Wide door I have added some modified parts with a 2.5mm wider GPIO door, you will need the bottom + door + 1 or the 2 types of top. As always with the top parts drag the door + top in to the slicer so they are aligned together. 28/01/24 I have added a new Prusa base for anyone who want to mount it to a Prusa MK3 printer, would be a nice overkill Otcoprint host. 19/01/24 Made a few changes there are now a number of files. There are 2 main versions and depending if you need the GPIO door and then each version has a variant depending if you need the camera cable slot. File GPIO CAM POE Raspbee Prusa Mount pi5_case_bottom.stl Yes X pi5_case_top_cam.stl Yes pi5_case_top.stl pi5_case_gpio_bottom.stl Yes Yes pi5_case_gpio_door.stl Yes Yes X pi5_case_gpio_top.stl Yes X (or below) pi5_case_gpio_top_cam.stl Yes Yes X (or above) pi5_case_gpio_bottom_prusa.stl Yes Yes pi5_case_bottom_ssd_gpio_widedoor.stl X pi5_case_bottom_ssd_gpio_prusa.stl X pi5_case_top_raspbee_II.stl X pi5_case_top_gpio_widedoor_POE.stl X pi5_case_top_gpio_open_widedoor_POE.stl X I have also included the 3mf files for the build plates of each version. Note that the print in place door might need some bending to release at first.