About this 3D model

Warning! Clips may loosen over time due to heat creep depending on the temperatures and filament material used. Proceed with Caution! As you can tell from the photo, I have it mounted on a USB to M.2 interface. It was getting too hot to touch to remove so I bought the cheapest heatsink on AliExpress (without thermal pad) I could have used a rubber band, but I prefer a solution that could assemble the heatsink without removing the drive. My earlier print in PLA started becoming loose after 1-2 hours at 50 deg C, now trying out ABS. So far it has been stable. For my heatsink and SSD, the thickness to clamp is 3mm. I included a 3.5mm version if you wish to use a thermal pad. If you have other thicknesses, let me know.