About this 3D model

SODA CAN DISPENCER _______________________________________________ About: With this soda can dispenser you can print in one piece, no supports needed. You can load in up to SIX cans from the top or front. Because of its size it can be placed anywhere! In your fridge, on your counter, on the table, on your desk and even next to your Bambu printer! Enjoy. ____________________________________________ Steps To Print: If you use the 3mf all settings will be set if not you can use the settings listed below. ____________________________________________ Dimensions + Print Time + Filament Used: 225mm Long (9 inch) 125mm Wide (5 inch) 135mm Tall (~5 inch) 240g of filament used 4 hour print time ____________________________________________ Settings: .28mm Layer Height Top Shell Layers: 0 Bottom Shell Layers: 0 Wall Line Count: 2 Infill Density: 20% Infill Pattern: Triangles (You can use what you think looks cool) __________________________________________________ Extra: ~~If you want to make your can dispenser unique then change the infill pattern to get a different shaped infill More Cool Prints: mwiller | Published - MakerWorld