About this 3D model

Bowden tube and CANbus cable support clips. Oftentimes switching from conventional setup of gazillion wires into cable chains is a bit tough as there are certain challenges with this. Small things can make big difference. Challenge this simple thing is addressing and solving more than effectively is how to organise bowden tube and CANbus / USB cable sagging and prevent it getting damaged on toolhead movements. Dimensions 4mm OD, 2.5mm ID, 16mm of length 4mm OD, 2.5mm ID, 8mm of length BOM (bill of materials) Printed Parts Printed parts 2 - 4 clips, depending on the size of your printer and therefore - bowden tube and cable length. PRINT GUIDELINES Here are print guidelines for you to follow in order to have decent success with printing parts: 3D PRINTING PROCESS FDM (fused deposition modeling) INFILL TYPE Grid, Gyroid, Honeycomb, Triangle or Cubic MATERIAL Enclosed printer — ASA, ASA-CF, ABS, ABS+, ABS-CF Un-enclosed printer — PLA, PLA+ or PETG INFILL PERCENTAGE 40% - 60% LAYER HEIGHT Recommended: 0.2mm WALL COUNT Recommended: 4 SOLID TOP/BOTTOM LAYERS Recommended: 5 EXTRUSION WIDTH Forced 0.4mm Side notes to the print guidelines A wall count of 4 is an absolute must to ensure the structural integrity of the parts. There is no need to go over the top with this. 4 walls are perfectly fine for this model. CHANGELOG Date Change 28.01.2024 Initial version (Rev1)